Base Warmer Burner 11440.0008 From Bunn Axiom P/N 38700.0030

Description

I am parting out a Bunn Axiom part number 38700.0030.
This part was in a 2/2 twin 240 volt machine. (Two upper warmers and two lower.) (Look for more parts in my other listings.) It would have cost too much to get this unit to 100% working condition and still sell it at a reasonable price. When I tested it, the only thing wrong was the displays did not display anything. This would require me to buy two control boards (38760.1010) at 0.00 each.
I do have the cabinet parts and panels. I assume these are not going to be needed by anyone, but, if you need something from the cabinet, I probably have it. I did not list any cabinet parts. Please send a message through eBay with the part(s) and/or part number(s) you need and I will give you a price. If you want it/them, I will then make a listing for you to buy from. I have most all other parts at the start of this listing. As they sell, of course, the inventory will diminish.
All of the parts I have listed were working in the unit before disassembling it. I didn't clean the parts. You may need to go over them a little, but they aren't that bad to begin with.
I have kept some parts for my own stock. I may need them on future repairs. I will sell them, however. If you don?t see your desired part listed please ask, I may have it.
Check all fasteners. They have been left loose. If your part is fastened to the unit, those fasteners are not included. Your existing fasteners are assumed to be reused. If this is not the case and you need them, I will include them at no additional cost upon your request.
If you see your part but don't want and/or need all that is included with it, I will break down the listing. Make an offer on the part describing what you want and the price you are willing to pay. I'll send pictures back to you accepting or counteroffering. It will be more accurate if you send me pictures of the part(s) you need to replace.
About this specific Part:
This is only one digit different from the side/top warmer in one of my other listings. The element legs is what the difference is. This base model is made for more of a flat installation. The other ones are angled down and are shorter and do not show when viewed from the top. The legs on this one protrude from under the black disc 2¾".